PARAMETER HP CONE CRUSHER

parameter hp cone crusher
The cone crusher is a secondary crusher after the primary crusher. Cone crusher is divided into HP cone crusher and sysmons cone crusher. HP cone crusher is the developed cone crusher based on the common cone crusher. Equiped with a hydraulic system and high pressure system, the HP cone crusher is easy to operate, mainten, and repair.
HP cone crusher driven by a rator on the top through eccentric shaft. The bottom is fixed, so the cone whirl as the orbit of top is a circle and the bottom is a dot. Between the inner wall and the cone, it's a cavity. The cavity is changed by the movement. So the materials is crushed and compressed into small pieces. Hydraulic system is used for setting the cone crusher and improve the efficiency.
The parameter of HP cone crusher:
HP cone crusher is divided into C and F , two types. C, short for coarse, which means the products are coarse relatively. F, short for fine, which means the products are fine, but not powder.
The model can be HP-160, HP-220, HP-315, HP-400, and the model is divided according to the size of cone crusher.
The discharge of coarse one can be 13mm and 6mm of the fine one. This is just depending on the cavity size.
The feeding opening is different every model and each cavity type. But it is about 70 - 300 mm. So the jaw crusher discharge size is important for cone crusher. The capacity is the same with feeding opening, which is not the same between the different models and types.
The power is 160 KW for the HP-160. This is determined by the size of cone crusher and its capacity. And the weight depends on the model too.

It's important to make a good choice of crushers for mining. If you need a plant, the production line can be designed by the experts and they will adjust the parameter of the crushers and make a best crusher for the materials.